FUTABA 16SZ Instruction Manual page 47

Connect the throttle rudder, aileron, elevator, pitch,
and other servos in accordance with the kit instruction
manual. For a description of the connection method, see
"Servos connection by model type".
Note: The channel assignment of the T16SZ
is different from that of our existing systems.
(The channel assigned to each function can
be checked at the Function menu of the
Linkage menu.)
incorrect, use the Reverse function of the
(Gyro side function)
carburetor can fully close at full trim throttle
cut.
and End point function (rudder angle
position can also be set with the End point
function.
48 ＜ Model Basic Setting Procedure ＞
*If any interactions are noticed, for a description of the
linkage correction function, please refer to the SWASH
function.
This function adjusts the throttle or pitch operation
curve in relation to the movement of the throttle stick for
each condition.
Call the throttle curve of each condition with the
condition select switch.
Normal curve creates a basic throttle curve
together with the pitch curve (Normal) so that the
easiest.
The low side Throttle curve creates a curve
The curve is not used when performing auto rotation
dives.
<
Call the pitch curve of each condition with the
condition select switch.
Set the pitch at hovering with the stick position at
*Stability at hovering may be connected to the throttle curve.
Adjustment is easy by using the hovering throttle function
and hovering pitch function together.
The idle up 1 pitch curve function creates a curve
º~6º.