Elevator - FUTABA 16SZ Instruction Manual

Air brake
This function is used when an air brake is
necessary when landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
be adjusted. (In side/Out side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
set the Auto Mode, which will link Airbrake to a
stick, switch, or dial. A separate stick switch or
dial can also be set as the ON/OFF switch.
setup screen shown below.
When using this
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
air brake is chosen.
Manual/Auto mode
selection
Manual: Switches the
function ON/OFF by
switch
Auto: Air brake function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
The value inside the
parentheses shows the
current rudder position.
146 ＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
Condition delay
setting and cut switch
setting.
Aileron 2
*The display screen is an example. The actual
screen depends on the Model Type.
To next page
Fine tuning setting

Elevator

Aileron 1
In speed
Out speed
（First） 0 〜 27 （ Slowly）
O f f s e t ： T h e o f f s e t
rate of ailerons, flaps,
and elevators can be
a d j u s t e d . Ta p t o t h e
corresponding setting
item. Adjust the rate.
Fine tuning：When a fine
tuning VR is set on the
next page, the ailerons',
flaps', and elevators' trim
rates can be adjusted.
Tap to the corresponding
setting item. Adjust the
rate.