FUTABA 16SZ Instruction Manual page 182

The model data (only latest version) of T14SG/FX-22 can be copied to T16SZ.
* SD card is required.
* The model data of T16SZ cannot be copied to T14SG/FX-22.
[Model data conversion method]
1. Attach an SD card that contains model data
of T14SG or FX-22 to the SD slot of a T16SZ.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in
the card. Select a model data that you want
to convert and push "CONVERT" → "Yes" key,
and the converter should begin converting
data.
4. If the convert succeeds, the converter will
show the following message. The converted
data are copied to the internal memory
of the T16SZ. Hence, if the T16SZ does not
have available space in its internal memory,
converts must fail.
183 ＜ Data ＞
5. The converter can accept model data
made by T14SG or FX-22 with the latest
software only. If you try to convert model
data made by old version software, the
converter must fail to convert and show
the following error message. If this message
is shown, do the following procedure to
update the model data in order to avoid
this limitation.
(a) First, update a T14SG or FX-22 to the latest software.
(b) Load the model data which failed to convert into the
T14SG or FX-22 with the latest software, and the model
data should be updated to the latest format.
(c) Save the updated model data to a SD card.
(d) Retry to convert the updated model data on a T16SZ.
* When SD card cannot be recognized, it may be able to
be used if it reformats by SD formatter offered from SD
Association.
complete check of operation with the model to
be used.
Check well all the directions of operation and
all the operation switches.