Table of Contents
Advertisement
Telemetry : Altitude [Variometer]
VARIO is a screen which displays / sets up the
variometer information from an optional altitude
be known.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
To ensure that the pilot is aware as to the model's
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
variometer reaches
above your set value.
↓ A downward arrow
indicates the alarm
will sound when the
variometer reaches
below your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
First, the set of a reference is required.
*Atmospheric pressure is changed according to the weather
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
*An altitude sensor or GPS sensor must be installed in the aircraft.
for ascent and descent. Additionally, depending
upon the rate of climb or descent, the tones vary to
indicate whether or not the airplane is climbing or
descending at a rapid rate.
*Only receiver voltage and EXT voltage can be used in
Sets the variometer
on which the alarm
operates.
Allows Melody to be
turned ON or OFF.
Alert set : variometer
functions.
● If this is set to Mode1-4,
≧
*When the screen is tapped for one second, the rate is reset
to the initial value.
＜ Linkage menu ＞
Variometer
a rise and dive are told
by a different melody.
Mode 1 : Little rise/dive
→ Melody changes
: sensitively
Mode 4 : Big rise/dive
→ Melody changes
: insensible
t
101
Advertisement
Table of Contents
