Alcatel-Lucent 1665 Installation Manual page 247

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
5
From the system view click Alarm List to verify that the circuit pack alarm is associated
with the optical port being tested.
........................................................................................................................................................................................................................
6
Select Configuration > Update System... > Update All.
Requirement: The flashing FAULT LED should extinguish on the OC-3 OLIU. There
should be no alarm indications on the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
7
Place the 15-dB LBO that was removed from the OC-3 OLIU (Port 1) and place it on the
IN connector directly below it (Port 2).
Connect the fibers labeled IN and OUT from the LGX to the OLIU (Port 2).
........................................................................................................................................................................................................................
8
Connect the Port 2 IN connector to the Port 2 OUT connector (at the LGX) of the OC-3
OLIU, using an optical fiber jumper cable.
Requirement: The FAULT LED on the OC-3 OLIU will begin flashing and the MN
and NE LEDs should be lit on the SYSCTL circuit pack.
After approximately 20 seconds the flashing FAULT LED should extinguish on the OC-3
OLIU and the FAULT, MJ and NE LEDs should be lit on the SYSCTL circuit pack.
........................................................................................................................................................................................................................
9
Remove the optical fiber jumper from the OC-3 OLIU (at the LGX).
Result:
and NE LEDs should be lit on the SYSCTL circuit pack.
........................................................................................................................................................................................................................
10
From the system view click Alarm List to verify that the circuit pack alarm is associated
with the optical port being tested.
........................................................................................................................................................................................................................
11
Select Configuration > Update System... > Update All.
Requirement: The flashing FAULT LED should extinguish on the OC-3 OLIU. There
should be no alarm indications on the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
12
Remove the 15-dB LBO from the OC-3 OLIU (Port 2) and place it on the IN connector
directly below it (Port 3).
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
The FAULT LED should begin flashing on the OC-3 OLIU and only the MN
OC-3 (low-speed) testing
6 - 3 7