Fiber Labeling Fiber Description - Alcatel-Lucent 1665 Installation Manual

Fiber labeling
............................................................................................................................................................................................................................................................
Yellow fiber
Yellow fiber is made up of a single-mode yellow colored fiber equipped with LC
connectors at both ends. The Yellow Fibers come in different lengths as well as custom
lengths. The length is given on the protection boot of the LC connector.
These fibers are used to make connections from the circuit pack to the LGX. Installation is
covered in 2, 4, 5, and 8.
Outside fiber
Outside fiber is the fiber connecting the customer equipment to the Alcatel-Lucent 1665
DMX. Depending on the customers specifications, these fibers may be any combination of
SC, FC, or ST connectors. The length of these fibers depends on the system interface
setup. This fiber is usually referred to as the Outside Bay or Plant Fiber.
Outside Bay Fiber management should be specified by the customer. It is beyond the
scope of this document to specify the route or dressings that the fiber should take once it
leaves the equipment bays.
............................................................................................................................................................................................................................................................
D- 2
Fiber description
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010