Alcatel-Lucent 1665 Installation Manual page 185

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW73 (FC-1X/2X) and LNW73C (FC-1X/2X with compression) installation (optional)
Follow this procedure only if installing LNW73 (FC-1X/2X) and LNW73C (FC-1X/2X
with compression) circuit packs into the Alcatel-Lucent 1665 DMX high-capacity shelf.
Note:
interface. This procedure will consist of two parts. Installing the circuit card and
installing the PTM per
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (A1, A2, B1,
B2, C1, C2, D1, D2) and/or growth slot (G1, G2) where the LNW73 or LNW73C circuit
pack will be installed.
Note:
function group unless the mains are equipped with VLF mains (LNW59, LNW82,
LNW504). With the VLF mains, both slots in a function or growth group may be
equipped.
........................................................................................................................................................................................................................
2
Remove the LNW73 or LNW73C from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf function group slot as required. Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion circuit pack slot as required.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
equipped with LNW73 or LNW73C circuit packs.
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
S
F T E P S
The LNW73 and LNW73C circuit pack requires PTM modules for the optical
Pluggable transmission modules (PTM) (p.
The LNW73 and LNW73C circuit packs can only be installed in slot 1 of any
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
Table I-3, Installation acceptance
for each additional function group and/or growth slot to be
Initial circuit pack installation
checklist.
E-1).
4 - 2 5