Alcatel-Lucent 1665 Installation Manual page 184

Data multiplexer
Hide thumbs Also See for 1665:
Table of Contents

Advertisement

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
LNW63 (1000BASE-SX/LX/LX10), LNW64 (8 GbE), LNW74 (10/100 T/F), LNW87 (FE/GBE PL) and
LNW170 (100/1G FXS) installation (optional)
Follow this procedure only if installing LNW63 (1000BASE-SX/LX/LX10), LNW64 (8
GbE), LNW74 (10/100 T/F), LNW87 (FE/GBE PL)
packs into the Alcatel-Lucent 1665 DMX shelf.
Note:
PTM modules for the Ethernet interface. This procedure will consist of two parts.
Installing the circuit card and installing the PTM per
transmission modules (PTM) (p.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (A1, A2, B1,
B2, C1, C2, D1, D2, G1 or G2) where the LNW63, LNW64, LNW74, LNW87, or
LNW170 circuit pack will be installed.
Note:
100 Base-F ports are available for use.
The LNW63, LNW64, LNW74, LNW87, and LNW170 circuit packs can only be
installed in slot 1 of any function group unless the mains are equipped with VLF
mains (LNW59, LNW82, LNW504). With the VLF mains, both slots in a function or
growth group may be equipped.
........................................................................................................................................................................................................................
2
Remove the LNW63, LNW64, LNW74, LNW87, or LNW170 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf fn slot. Do NOT engage the circuit pack in the
backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion function group circuit pack slot as required.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
LNW63, LNW64, LNW74, LNW87, or LNW170 circuit packs.
........................................................................................................................................................................................................................
6
Install the PTM module per
............................................................................................................................................................................................................................................................
4 - 2 4
The LNW63, LNW64, LNW74, LNW87, and LNW170 circuit packs require
When LNW74 is installed in the G1 or G2 position, only the faceplate optical
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1
through
Step 4
Appendix
E-1).
for each additional function group to be equipped with
E,
Pluggable transmission modules (PTM) (p.
Initial circuit pack installation
and LNW170 (100/1G FXS) circuit
,
Appendix
E,
Pluggable
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
E-1).
July 2010

Advertisement

Table of Contents
loading

Table of Contents