Alcatel-Lucent 1665 Installation Manual page 178

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW7(28DS1PM), LNW8(56DS1E1), LNW801(56DS1E1) low-speed installation (optional)
Follow this procedure only if installing LNW7 (28DS1PM), LNW8 (56DS1E1), or
LNW801 (56DS1E1) circuit packs into the Alcatel-Lucent 1665 DMX high-capacity
shelf.
Note:
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slots where
LNW7, LNW8, or LNW801 circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW7, LNW8, or LNW801 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1 or D1 as required). Do NOT engage
the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a protection circuit pack is required, continue with
pack into the protection circuit pack slot (A2, B2, C2 or D2 as required), then proceed to
Step 7.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW7, LNW8, or LNW801 from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, or D2 as required). Do NOT engage
the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
7
Repeat
LNW7, LNW8, or LNW80 circuit packs.
............................................................................................................................................................................................................................................................
4 - 1 8
S
F T E P S
LNW7 is not supported with VLF main circuit packs.
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 6
Table I-3, Installation acceptance
for each additional function group to be equipped with
Initial circuit pack installation
checklist.
Step 5. If not, install a blank circuit
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010