Alcatel-Lucent 1665 Installation Manual page 136

Cable and fiber installation
............................................................................................................................................................................................................................................................
1. Sync cable with a molded D-Sub 9-Pin (DB-9) connector
2. Sync cable with a wire-wrap DB-9 connector.
Note:
output (red) termination for timing. See
timing reference) connections" (p. 3-51)
Sync cable with molded DB-9 connector procedure
Perform the following steps when using a Sync cable with a molded DB-9 connector.
........................................................................................................................................................................................................................
1
Connect the DB-9 connector end of the Sync cable to the SYNC1 (J9) port on the Alcatel-
Lucent 1665 DMX high-capacity shelf backplane. See
molded DB9 connector installation" (p.
............................................................................................................................................................................................................................................................
3 - 4 6
Each of the Sync connections on the backplane provides an input (gray) and
Table 3-21, "Synchronization cable (DS1
for the pinouts.
Figure 3-13, "Sync cable with
3-47).
Sync cable installation
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010