........................................................................................................................................................................

Turn-up and test the LNW785 8-channel OMD

Description

This section provides the procedure to provision and test an optical span using the 8-

channel OMD LNW785 circuit pack. The procedure requires an LNW785 at both ends of

the span and that there is least one OC-192/10Gbps source at each end of the span. The

source OC-192 could be an LNW502, LNW59, or an OC-192/10Gbps from a alien shelf

but the source MUST be compatible with the wavelengths on the LNW785. The LNW502

or LNW59 must be equipped with X10G52C5, X10G53C5, X10G54C5, or X10G55C5. If

using an alien 10Gbps source, see

wavelengths specifications.

If the LNW705 is used as the test signal, proceed to

muxponder" (p. 9-6)

................................................................................................................................................

Determine and document the test signal frequency.

................................................................................................................................................

Install the LNW785 into the Alcatel-Lucent 1665 DMX shelf by opening both faceplate

latches and seating in the slot while closing the latches.

Note:

to be configured as an add/drop, it is recommended that the Growth slots are not used

because the passthrough fibers would have to route over the SYSCTL.If the Main slots

are not equipped with VLF mains (LNW59, LNW82, LNW504), then the circuit packs

in a Function/Growth slot must be the same type.

................................................................................................................................................

Create OCH Cross-connections

Select Configuration > OCH Cross-connections from the System View

................................................................................................................................................

Select the Create a new OCH cross-connection radio button in the OCH Cross-

Connection Wizard. Click Next.

Click the 2-way Add/Drop radio button from the cross-connection list. Click Next.

........................................................................................................................................................................

9 - 4

The LNW785 can be installed in any Function/Growth slot. When the shelf is

Turn-up and test the LNW785 8-channel OMD

Table 9-1, "Channel/port assignments" (p. 9-17)

"Turn up and test the LNW705

CIT.

Alcatel-Lucent 1665 DMX R9.0

365-372-304R9.0 Issue 2

for the

July 2010

Table of Contents