Important Notes; Standards; Items Supplied; Notices - C-TEC CAST ZFP Installation, Maintenance & Operating Manual

CAST ZFP Analogue Addressable Fire Alarm Panel
Symbols
General Warning Sign

1 IMPORTANT NOTES

1.1

Standards

1.2

Items Supplied


CAST ZFP Fire Alarm Control Panel, as ordered.

Installation, Maintenance & Programming manual (this manual) – Explains how to install, commission
and maintain the fire alarm control panel. This manual must not be left accessible to the user.

User Manual and Log Book (Document No. DFU5030050) – Gives detailed operational information
and details about the panel's touchscreen, indicators and controls.

Quick start guides for users (Document No. DFU5030060) and engineers (Document No. DFU5030010)
– Summarize key information provided in the main manuals.

Key for unfastening / securing the panel lid (key number 801).

Electrical accessory pack, containing:
1 x 20mm T 2 A H 230 V ceramic fuse (spare primary fuse)
1 x 7.5 A MINI
1 x set of battery link wires and nylon cable ties
4 x 6K8 0.25W EOL resistors for conventional sounder circuits (2) and auxiliary inputs (2)
2 x 470R 0.25W trigger resistors for auxiliary inputs I/P1 & I/P2.
1.3

Notices

WARNINGS!
This equipment must only be installed and maintained by a suitably skilled and
technically competent person.
Training Course before handling the panel.
This equipment is a piece of Class 1 permanently connected equipment and MUST
BE EARTHED.
ALWAYS isolate the panel's Mains and battery backup supplies before making
connections to its PCBs.
Anti-static handling guidelines
Make sure that handling precautions for electro-static devices (ESD) are taken immediately
before handling PCBs and other ESD components. Before handling any ESD items,
engineers should get rid of any electro-static charge by touching a sound safety earth.
Always handle PCBs by their sides and avoid touching any electronic components. PCBs
should be stored in a clean, dry place that is free from vibration, dust and excessive heat.
Disclaimer
Errors and omissions excepted (E&OE). No responsibility can be accepted by the manufacturer
or distributors of this range of fire panels for any misinterpretation of an instruction or guidance
note or for the compliance of the system as a whole. The manufacturer's policy is one of
continuous improvement and we reserve the right to make changes to product specifications at
our discretion and without prior notice.
Page 7 of 60  Approved Document No. DFU5030000 Rev 4  Installation and Programming Manual
Read these instructions thoroughly before installation and operation
®
automotive blade fuse (spare battery fuse)
Danger Electrical Hazard
ZFP1/CA
ZFP2/CA
ZFP4/CA
ZFP1/40/CA
ZFP2/40/CA
ZFP4/40/CA
Ensure you have attended C-TEC's Authorised
2831-CPR-F4508
2831-CPR-F4509
2831-CPR-F4510
2831-CPR-F4511
2831-CPR-F4512
2831-CPR-F4513
DOP0000076