CAST ZFP Analogue Addressable Fire Alarm Panel
8.6.9
Edit Input Group Name
This function allows text descriptions for Input Groups to be edited.
Enter AL3 (4444) > Commissioning Functions press the
the one shown below appears.
8.6.10
Edit Output Group Name
This function allows text descriptions for Output Groups to be edited.
Enter AL3 (4444) > Commissioning Functions press the
the one shown below appears.
8.6.11
Setup Panel Printer
This function only applies to panels with an integrated printer fitted.
8.6.12
Setup Networking
These function only applies to networked panels.
8.6.13
Select Language
This function changes the text language of the touchscreen buttons and menus. The default language is English.
8.6.14
Synchronise Network Data
These function only applies to networked panels.
8.6.15
LCD Auto-Dimming
This function adjusts the touchscreen's power save mode.
Enter AL3 (4444) > Commissioning Functions press the
below appears.
Page 47 of 60 Approved Document No. DFU5030000 Rev 4 Installation and Programming Manual
Amend the text descriptions by following the same operating
procedure detailed in section 8.6.8.
Amend the text descriptions by following the same operating
procedure detailed in section 8.6.8.
By default, the LCD backlight will switch off after 120 seconds.
To select a different dimming time press the 'Secs' field (120
shown left) and use the
or enter the time directly into the field using the touchscreen's
numeric keypad.
Enter '0' to disable power save mode.
button and a window similar to
button and a window similar to
button and the window shown
and
buttons to adjust the time,