CAST ZFP Analogue Addressable Fire Alarm Panel
5 INSTALLATION
Note: See section 8.2 for a recommended shortform installation procedure.
5.1
Enclosure Description
The panel's enclosure comprises of a hinged steel lid and a steel back box which houses a power supply unit
(PSU) and several printed circuit boards (PCBs) mounted on a metal chassis, as shown in Fig.2 below. Space
is available inside the back box for the backup batteries.
The panel can be surface or semi-flush wall mounted (a bezel is required for semi-flush mounting). The
standard ZBOXS, 1 to 4 loop version enclosure, is shown below.
Fig.2 – Location of Standard 1 to 4 Loop Version Components
Fig.2 key:
Lid Hinge Pins – 2 off
A
B
Module (Part No. Z48) 40 zone, 5 switches, 10 LEDs
20-way heavy duty brass earth bar.
C
DO NOT operate equipment without connecting cable screens to this bar.
D
Control/Display Module (Part No. Z41) incorporates the touchscreen
E
Lid Aperture
F
Lid (requires Key No. 801)
Installation and Programming Manual Approved Document No. DFU5030000 Rev 4 Page 12 of 60
G
PSU
H
PCB Stepped Chassis
I
Main 1 or 2-Loop PCB
2-Loop PCB adds two additional loops
J
(Part No. Z02LOOP/CA).
A-Bus PCB. Optional.
K
ZHN Network PCB. Optional.
L
Space for up to 2 x 12V, 17Ah batteries