Z16 Zone & Conventional Sounder Pcb Features - C-TEC CAST ZFP Installation, Maintenance & Operating Manual

CAST ZFP Analogue Addressable Fire Alarm Panel
6.4 Z16 Zone & Conventional Sounder PCB Features
Feature
A-Bus PCB (Z16):
Cabling:
Protocol:
Powered from:
No. of Detection Zones:
No. of Sounder Circuits:
Installation:
Number of PCBs:
PCB size (mm):
Common features:
Zone Sounder PCB
(Z16) features:
(shown below)
Installation and Programming Manual  Approved Document No. DFU5030000 Rev 4  Page 24 of 60
Details
CAST ZFP Detection Zone & Conventional Sounder PCB (full size). Part No. Z16.
2 core screened cable (plus 2 core for power).
RS485, 19200 BAUD, 8 Data, no Parity, 1 stop bit.
Note: We recommend an Aux EN 54-4/A2 PSU (external to the CAST ZFP panel – not supplied).
The PCB terminal labelled 'Ex' is used to report a fault from the Aux PSU. It is triggered from
an active IO signal from an open collector (O/C), or volt-free (with 0V common) relay O/P.
4 x Conventional detection zones, each with a maximum of 10 conventional devices.
2 x 1A Conventional sounder outputs. Programmable and monitored.
PCBs normally installed within a CAST ZFP panel but may be extended up to 1km for
non-EN 54-2 functions.
Connect up to 15 A-Bus PCBs per Main 1 or 2-Loop PCB.
67 w x 165 h x 17 d.

24V supply inputs.

A-Bus RS485 connections (B, A, 0) to Main 1 or 2-Loop PCB.

Comms connections (PL2/PL3); Power In/Power Out connections (PL5/PL6).

15 available addresses (set using DIP switch SW1, see section 6.2).

Isolated RS485 multi drop.

LED indication for polling and power.

Standard 5mm fixed PCB connectors, accept up to 2.5mm

Common features (as above).

4 x Conventional zone inputs.

2 x 1A Monitored, conventional sounder outputs.

Each circuit is programmable using CAST ZFP Programming Tools.
Note: The Z16 DOES NOT have the facility to 'pulse sounders'.

Separate LED indication provided for each zone and sounder circuit.
2
cable.