Installing The Nortel Networks Modem Configuration Utility - Nortel CallPilot Mini Installation And Maintenance Manual

68 Modem Access
11 Select the Unencrypted password (PAP) option and clear the other options.
12 Click the OK button.
A warning message appears.
13 Click the Yes button.
14 Click the Networking tab.
15 In the Type of dial-up server I am calling drop list, click PPP:Windows 95/98/NT4/2000,
Internet.
16 Click the Settings button.
17 Ensure the following options are selected:
Enable LCP extensions
Enable software compression
Negotiate multi-link for single link connections
18 Click the OK button.
19 Select the Internet Protocol (TCP/IP) option.
20 Click the Internet Protocol (TCP/IP) heading and then click the Properties button.
21 Select the Use the following IP address option.
22 Enter an IP address that is on the same network segment as the CallPilot system.
For example, if the CallPilot IP address is 192.168.0.1, enter 192.168.0.2.
Note: The IP address you enter here is used to identify your computer during the
modem connection. It does not affect the LAN configuration of your computer.
23 Click the OK button to close the Internet Protocol (TCP/IP) properties.
24 Click the OK button to close the Dialup properties.

Installing the Nortel Networks Modem Configuration Utility

Your modem requires a special configuration to access the CallPilot modem. The Modem
Configuration Utility allows you to easily switch between the configuration for the CallPilot
modem and the configuration for normal modem use. Each time that you run this application you
will need to reboot your PC for the changes to take effect.
To install the Nortel Networks Modem Configuration Utility:
1 Load the CallPilot CD in the CD-ROM drive of your computer.
2 Open the CD folder and open the Optional Software folder.
3 Open the Modem Configuration Utility folder.
4 Copy the file CPsecureModem.exe to a folder on your computer.
5 Remove the CallPilot CD from your computer.
P0604219 03