Changing The Ip Address Using An Ethernet Crossover Cable; Figure 4 Ethernet Crossover Cable - Nortel CallPilot Mini Installation And Maintenance Manual

40 Chapter 5 Initializing the CallPilot Mini

Changing the IP address using an Ethernet crossover cable

Using an Ethernet crossover cable, you can connect the CallPilot Mini to your computer. With this
connection, you can use CallPilot Manager to change the CallPilot Mini IP address before you
connect it to the network.
Note: If you do not have access to the CallPilot Mini through the network, you can use an
Ethernet crossover cable to configure all of the CallPilot Mini parameters.
To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseT
Ethernet card and support TCP/IP protocol.

Figure 4 Ethernet crossover cable

3TD+
6TD-
1RD+
2RD-
Note: An Ethernet crossover cable is available as a separately available part. For
information about obtaining an Ethernet crossover cable, contact your Nortel Networks
supplier.
Connecting the Ethernet crossover cable
1
Shut down the computer.
2
Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot Mini.
3 Connect the other end of the cable to the network interface card on your computer.
4 Start the computer.
5 Use the Quick Install Wizard to initialize the CallPilot Mini.
For information about how to use the Quick Install Wizard, refer to
Wizard" on page
P0604219 03
41.
Figure 4 shows the connections required.
3TD+
6TD-
1RD+
2RD-
"Running the Quick Install