Connecting The Callpilot Mini; Table 2 Port A And Port B Pinouts - Nortel CallPilot Mini Installation And Maintenance Manual

24 Chapter 4 Installing CallPilot Mini

Connecting the CallPilot Mini

1 Open the CallPilot Mini by inserting a flat screwdriver into the slot on the right-hand side of
the door and pressing the tab out of the way.
Figure 3 shows the inside of the CallPilot housing and points out the cable jacks.
2
Connect a TCM cable to Port A and to Port B.
Table 2 shows the pin out of Port A and Port B.

Table 2 Port A and Port B Pinouts

Pin number Port A
1
2
3
4
5
6
3
Connect the other end of the TCM cables to station ports on your telephone system.
Note: Do not connect the Ethernet cable for your LAN to the Ethernet port until you
determine if the CallPilot Mini IP address is compatible with the network. For
information about the default CallPilot Mini IP address and how to change the IP
address, refer to
4 Connect the power cable to the CallPilot Mini and the wall socket.
5
Run all the cables through the cable trough at the top of the CallPilot Mini.
6
Close the lid.
P0604219 03
no connection
TCM 3
TCM 1
TCM 1
TCM 3
no connection
"Connecting to the CallPilot Mini" on page
Port B
no connection
TCM 4
TCM 2
TCM 2
TCM 4
no connection
37.