Led 1 And Led 2 Are Blinking Quickly; Leds 1 To 4 Turn On At Power Up But Do Not Briefly Turn Off During Start Up; Starting Up; Led 6 Does Not Turn On After Callpilot Mini Has Finished Starting Up - Nortel CallPilot Mini Installation And Maintenance Manual

62 Chapter 10 Troubleshooting

LED 1 and LED 2 are blinking quickly

If LED 1 and LED
"The Power-on Diagnostics fail" on page

LEDs 1 to 4 turn on at power up but do not briefly turn off during start up

LEDs 1 to
the hardware initialization has failed. Refer to
One or more of LEDs 1 to 4 do not turn on after CallPilot Mini has finished

starting up

LEDs 1 to
LEDs are off, the LED number indicates the line number that is not connected to the telephone
system. If the lines are supposed to be connected to the telephone system:
1 Check the wiring between the telephone system and the CallPilot Mini.
2 Make sure the wiring between the telephone system and the CallPilot Mini is less than 15
meters (50 feet) long.

LED 6 does not turn on after CallPilot Mini has finished starting up

If LED
application has failed to start. Refer to
P0604219 03
2 are blinking quickly, the Power-on Diagnostics have failed. Refer to
4 turn off briefly during the start up process. If these LEDs do not turn off briefly,
4 indicate the lines that are connected to the telephone system. If any of these
does not turn on a few minutes after CallPilot Mini has finished starting up, the
60.
"The Power-on Diagnostics fail" on page
"CallPilot Mini does not function at all" on page
60.
60.