Upgrading Callpilot Mini; Upgrading The Callpilot Software Version - Nortel CallPilot Mini Installation And Maintenance Manual
Nortel callpilot mini voice messaging: user guide
Hide thumbs
Also See for CallPilot Mini:
- Installation and maintenance manual (94 pages) ,
- Reference manual (72 pages) ,
- Quick reference manual (28 pages)
Table of Contents
Advertisement
Chapter 9
Upgrading CallPilot Mini
This section describes how to upgrade the CallPilot Mini. You can upgrade:
•
the CallPilot software
•
the message storage
Upgrading the CallPilot software version
Make sure that there is no one using the CallPilot Mini before you start the upgrade.
1
Nortel Networks recommends that you backup your CallPilot information before you upgrade
the CallPilot software. For information about how to backup CallPilot, refer to
the CallPilot information" on page
2
Put on an anti-static strap and connect it to a grounded metal object.
3
Unplug the power connector from the CallPilot Mini.
4
Insert the upgrade cartridge in the top PCMCIA slot.
For the location of the PCMCIA slots, refer to
Caution: The upgrade cartridge must be inserted in the top PCMCIA slot.
If the upgrade cartridge is inserted in the bottom PCMCIA slot, your current software
overwrites the upgrade cartridge and all of your programming is lost. Contact your
Nortel Networks Service Representative for assistance.
Caution: Never install the upgrade cartridge or the feature cartridge in any device
other than the CallPilot Mini. These cartridges can be corrupted by inserting them in
other devices.
5
Restore power to the unit.
The CallPilot Mini starts up. During the start up, the LEDs turn on and off in the following
sequence:
•
LEDs 1 to 4 light for approximately 20 seconds
•
LEDs 1 to 4 turn off for approximately 25 seconds
6
The CallPilot Mini copies the files from the upgrade cartridge to the feature cartridge. During
the upgrade, the LEDs turn on and off in the following sequence:
•
LEDs 1 to 4 cycle on and off, one at a time, for approximately 8 to 10 minutes
•
LEDs 1 to 4 turn off for approximately 40 seconds
•
some or all of the
on these ports
7
Wait until the
49.
LEDs 1 to 4 may light to indicate TCM connections to the CallPilot
LED turns on.
Figure 1 on page
18.
CallPilot Mini Installation and Maintenance Guide
"Backing up
Advertisement
Table of Contents
