Running The Quick Install Wizard; Table 13 Quick Install Wizard Parameters For A Callpilot Mini - Nortel CallPilot Mini Installation And Maintenance Manual

Running the Quick Install Wizard

The Quick Install Wizard appears the first time you startup CallPilot Manager. The Quick Install
Wizard is a single page that gathers enough information to set up a working system. It then applies
the information and restarts the system.
You can reach CallPilot Manager from another computer through a LAN connection, WAN/
Internet connection or an Ethernet crossover cable. All of these methods create an IP connection
that allows you to run CallPilot Manager.
Use the following procedure to run the Quick Install Wizard:
1 Launch your browser.
2 In the URL address box, type the CallPilot Mini IP address.
For example: HTTP://192.168.110.10
Note: You must include HTTP:// to access CallPilot Manager.
The Quick Install Wizard screen appears. Depending on your system, this can take several
minutes to appear.
3
Configure the Quick Install parameters for a CallPilot Mini according to

Table 13 Quick Install Wizard parameters for a CallPilot Mini

Field name
IP Address
Subnet Mask
Description
Enter the IP Address or Fully Qualified Domain Name (FQDN) for the CallPilot Mini. If
you do not know the IP Address or FQDN, contact your network administrator.
This is the IP Address or FQDN you will use to access the CallPilot Mini using CallPilot
Manager.
Changes to the IP Address take effect when you reboot the CallPilot Mini.
If this is a re-install, the IP Address shows the current settings, not the factory default.
Warning: If you enter an FQDN in the IP Address box, you must
ensure that the FQDN for the CallPilot Mini is in the same subnet as is
specified by the Subnet Mask and the Default Gateway IP address. If
you enter an FQDN that is not in the same subnet, you may cause the
CallPilot Mini to continuously reboot. To correct this problem, use the
serial interface to change the IP address of the CallPilot Mini. For more
information, refer to
page 37.
Enter the Subnet Mask for the CallPilot Mini. If you do not know the Subnet Mask,
contact your network administrator.
Changes to the Subnet Mask take effect when you reboot the CallPilot Mini.
If this is a re-install, the Subnet Mask shows the current settings, not the factory default.
Chapter 5 Initializing the CallPilot Mini
"Changing the IP address using a serial cable" on
CallPilot Mini Installation and Maintenance Guide
41
Table 13.