What To Do When The Server Fails To Boot Into Service - Nortel CallPilot User Manual

Error message
NVRAM / CMOS / PASSWORD
cleared by Jumper
<CTRL_N> Pressed
Replacement parts
Before replacing any parts on your server, refer to the Nortel product
catalog for the part codes.
The following table shows a list of the current part numbers of field
replacement units for the 600r at the time of publishing. Refer to the latest
Nortel product catalog for any interim updates to the part numbers.
Table 7
Field replacement units (FRUs)
Description of part
Hard disk drive mechanical tray
External SCSI terminator
Power supply
Fanset
Hard drive
DDR memory (x2)
DVDROM/CDRW combo

What to do when the server fails to boot into service

This section suggests tasks you can perform to determine why the server
fails the bootup cycle.
Copyright © 2007, Nortel Networks
.
What to do when the server fails to boot into service 27
CAUTION
Risk of system damage
The use of parts that are not supplied by Nortel can cause serious
system problems or void your Nortel warranty.
Nortel CallPilot
600r Server Maintenance and Diagnostics
NN44200-703 01.04 Standard
5.0 25 April 2007
Description
NVRAM, CMOS, and passwords are
cleared. Power the system down and
remove the jumper.
The CMOS is ignored and NVRAM is
cleared. You must enter Setup.
Part number
NTRH9205E5
NTRH9244E6
NTRH9245E5
NTRH9246E5
NTRH9247E6
NTRH9224E5
NTRH9232E5