Working With The Channel Monitor; To View Or Work With Call Channel States; Nortel Callpilot; 600R Server Maintenance And Diagnostics - Nortel CallPilot User Manual

60 Chapter 5 Monitoring multimedia hardware
3
4

Working with the Channel Monitor

The Channel Monitor shows the status of call channels. The call channels
are the connections between the server and the switch that carry the call
signals to CallPilot.

To view or work with call channel states

Step
1
2
Copyright © 2007, Nortel Networks
.
Do one of the following:
If you want to stop or start
all of the channels associated with
a DSP
only one or several channels that
are associated with a DSP
Click Courtesy Stop or Start, as required.
Result: If you clicked Courtesy Stop or Start, you are asked to
confirm the Courtesy Stop or Start. Click OK.
The selected channels change to off-duty or on-duty status,
according to the action you chose.
Note: If the buttons are not available, wait a few seconds for
the screen to refresh.
Action
Log on to CallPilot Manager.
Click Maintenance → Channel Monitor.
Result: The Channel Monitor screen appears, showing the DS30X
(also known as DS0) channels associated with each DS30X link.

Nortel CallPilot

600r Server Maintenance and Diagnostics

NN44200-703 01.04 Standard

5.0 25 April 2007
Then
select the Select All check box to
the left of the DSP that you want
to stop or start.
Repeat this step for each DSP.
select the check box for each
channel that you want to stop or
start.
—End—