76 Chapter 7 Replacing basic chassis components
To remove the front bezel
Step
1
2
To replace the front bezel
Step
After the CallPilot server maintenance is complete, replace the front bezel.
1
2
Copyright © 2007, Nortel Networks
.
Action
Figure 17
Front bezel
Loosen the thumbscrew fasteners (A) on both sides of the front
bezel. You cannot remove the screws from the front bezel. For more
details, see
Figure 17 "Front bezel" (page
CAUTION
Risk of equipment damage
Support the front bezel while loosening the thumbscrew
fasteners, as the front bezel is not held onto the front
panel with another mechanism.
Hold the front bezel by the thumbscrew fasteners and lift the bezel
towards you. Place it in a secure location while you service the
server.
Action
Align the thumbscrew fasteners on the front bezel with the threaded
holes in the front panel.
Tighten the thumbscrew fasteners.
Nortel CallPilot
600r Server Maintenance and Diagnostics
NN44200-703 01.04 Standard
5.0 25 April 2007
76).
—End—
—End—