Back Up Via Console Port; Figure 93 Menu 24.5 System Maintenance: Backup Configuration; Figure 94 Menu 24.5 System Maintenance: Starting Xmodem Download Screen - Nortel 222 User Manual

Table 47 General commands for GUI-based TFTP clients
Command
Remote File
Binary
Abort
Refer to Chapter 17, "Remote Management," on page 209
configurations that disallow TFTP and FTP over WAN.

Back up via console port

Back up configuration via the console port by following the HyperTerminal
procedure. Procedures using other serial communications programs are similar.
Display menu 24.5 and enter "y" at the screen shown in

Figure 93 Menu 24.5 System Maintenance: Backup Configuration

Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
Figure 94 shows the screen which indicates that the Xmodem download has
started.

Figure 94 Menu 24.5 System Maintenance: Starting Xmodem Download Screen

You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
Run the HyperTerminal program by clicking Transfer, then Receive File as
shown in Figure
Chapter 15 Firmware and configuration file maintenance 185
Description
This is the filename on the Business Secure Router. The filename for the
firmware is "ras" and for the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
95.
Nortel Business Secure Router 222 Configuration — Advanced
for information about
Figure 93.