Nortel 222 User Manual page 278

278 Appendix H Command Interpreter
Table 69 Sys commands
Command
udp
udp switch
udp addr
udp port
parse
brief
version
view
wdog
switch
cnt
romreset
server
NN47922-501
[on|off]
<addr>
<port>
[[start_idx], end_idx]
<filename>
[on|off]
[value]
access
<telnet|ftp|web|icmp|snmp|
dns> <value>
load
disp
port <telnet|ftp|web|snmp>
<port>
save
secureip <telnet|ftp|
web|icmp|snmp|dns> <ip>
Description
Sends the trace packets to another
system using UDP.
Enables or disables the sending of the
trace packets to another system using
UDP or displays the current setting.
Sets the target IP address for sending
trace packets using UDP.
Sets the UDP port (should match that
of the target IP address) for sending
trace packets using UDP.
Displays detailed packet details of the
packet range specified.
Displays a brief listing of packet
contents.
Displays the RAS code and driver
versions.
Displays the specified text file.
Turns the watchdog firmware
protection feature on or off.
Sets (0-34 463) or displays the current
watchdog count (in 1.6 sec units).
Restores the factory default
configuration file.
Use these commands to configure
remote server management.
Sets the server access type.
Loads server information.
Displays server information.
Sets the server port.
Saves server information.
Sets server secure IP address.