Remote Management Limitations - Nortel 222 User Manual

Table 52 Menu 24.11 – Remote Management control
Field
Certificate
Authenticate Client
Certificates
After you fill this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC
to Cancel" to save your configuration, or press [ESC] to cancel.

Remote Management Limitations

Remote management over LAN or WAN does not work when:
1
A filter in menu 3.1 (LAN) or in menu 11.1.4 (WAN) is applied to block a
Telnet, FTP, or Web service.
2
You disable that service in menu 24.11.
3
The IP address in the Secured Client IP field (menu 24.11) does not match
the client IP address. If it does not match, the Business Secure Router
disconnects the session immediately.
4
There is an SMT console session running.
5
There is already another remote management session of the same type (web,
FTP or Telnet) running. Only one remote management session of the same
type can run at one time.
6
There is a web remote management session running with a Telnet session. A
Telnet session is disconnected if you begin a web session; it does not begin if
a Web session is already running.
7
There is a firewall rule that blocks remote management.
Description
Press [SPACE BAR] and then [ENTER] to select the certificate that
the Business Secure Router uses to identify itself. The Business
Secure Router is the SSL server and must always authenticate itself
to the SSL client (the computer that requests the HTTPS connection
with the Business Secure Router).
Select Yes by pressing [SPACE BAR], then [ENTER] to require the
SSL client to authenticate itself to the Business Secure Router by
sending the Business Secure Router a certificate. To do that, the
SSL client must have a CA-signed certificate from a CA that has
been imported as a trusted CA on the Business Secure Router (see
Appendix C, "Importing certificates," on page 233
Nortel Business Secure Router 222 Configuration — Advanced
Chapter 17 Remote Management 211
for details).