Example Of Ftp Commands From The Command Line; Gui-Based Ftp Clients; Figure 92 Ftp Session Example; Table 46 General Commands For Gui-Based Ftp Clients - Nortel 222 User Manual

182 Chapter 15 Firmware and configuration file maintenance
5
6
7

Example of FTP commands from the command line

Figure 92 FTP Session Example

GUI-based FTP clients

Table 46
clients.

Table 46 General commands for GUI-based FTP clients

Command
Host Address
Logon Type
Transfer Type
NN47922-501
Enter bin to set transfer mode to binary.
Use get to transfer files from the Business Secure Router to the computer, for
example, get rom-0 config.rom transfers the configuration file on the
Business Secure Router to your computer and renames it config.rom. See
earlier in this chapter for more information on filename conventions.
Enter quit to exit the ftp prompt.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 config.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
describes some of the commands that you can see in GUI-based FTP
Description
Enter the address of the host server.
Anonymous.
This is when a user ID and password is automatically supplied
to the server for anonymous access. Anonymous logons will
work only if your ISP or service administrator has enabled this
option.
Normal.
The server requires a unique User ID and Password to log on.
Transfer files in either ASCII (plain text format) or in binary
mode.