Remote Node Filter - Nortel 222 User Manual

Table 22 Remote Node Network Layer Options Menu Fields
Field
Version
Multicast

Remote Node filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press
[SPACE BAR] to set the value to Yes. Press [ENTER] to open
Remote Node Filter.
Use menu 11.1.4 to specify the filter sets to apply to the incoming and outgoing
traffic between this remote node and the Business Secure Router to prevent
certain packets from triggering calls. You can specify up to 4 filter sets separated
by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are
accepted in this field. For more information about defining the filters, refer to
Chapter 11, "Filter configuration," on page
encapsulation, you have the additional option of specifying remote node call filter
sets.
Description
Press [SPACE BAR] and then [ENTER] to select the RIP
version from RIP-1/RIP-2B/RIP-2M or None.
IGMP (Internet Group Multicast Protocol) is a
network-layer protocol used to establish membership in a
Multicast group. The Business Secure Router supports
both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press [SPACE BAR] to enable IP Multicasting or select
None to disable it.
After you complete filling in Menu 11.1.2 Remote Node
Network Layer Options, press [ENTER] at the message
"Press ENTER to Confirm..." to save your configuration
and return to menu 11.1, or press [ESC] at any time to
cancel.
Nortel Business Secure Router 222 Configuration — Advanced
Chapter 6 Remote Node setup 95
135. For PPPoE or PPTP
Example
N/A
None
(default)
Menu 11.1.4-