Configuration File Upload; Ftp File Upload Command From The Dos Prompt Example; Figure 103 Telnet Into Menu 24.7.2 System Maintenance - Nortel 222 User Manual

Configuration file upload

The screen shown in

Figure 103 Telnet Into Menu 24.7.2 System Maintenance

Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "nnadmin" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation,
which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
To upload the firmware and the configuration files, follow the examples in the rest
of this chapter:

FTP file upload command from the DOS prompt example

1
Launch the FTP client on your computer.
2
Enter "open", followed by a space and the IP address of your Business Secure
Router.
3 Press [ENTER] when prompted for a username.
4
Enter your password as requested (the default is "PlsChgMe!").
5
Enter "bin" to set transfer mode to binary.
6
Use "put" to transfer files from the computer to the Business Secure Router,
for example, "put firmware.bin ras" transfers the firmware on your computer
(firmware.bin) to the Business Secure Router and renames it "ras". Similarly,
"put config.rom rom-0" transfers the configuration file on your computer
Chapter 15 Firmware and configuration file maintenance 191
Figure 103 appears when you access menu 24.7.2 via Telnet.
Press ENTER to Exit:
Nortel Business Secure Router 222 Configuration — Advanced