Nortel 222 User Manual page 292

292 Appendix H Command Interpreter
Table 73 IPSec commands
Command
ikeDelete <rule index>
policyEdit <rule index>
policySave
ipsecList
policyList
policyDelete <rule index>
policyConfig
saIndex
active
lcAddrStart
protocol
controlPing
controlPingAddr
lcAddrType
lcAddrEndMask
lcPortStart
lcPortEnd
rmAddrType
rmAddrStart
rmAddrEndMask
rmPortStart
rmPortEnd
btNatActive
NN47922-501
Description
Deletes the specified IPSec rule.
Edits the specified IP policy.
Saves the IP policy.
Displays a summary of the IPSec (phase
2) rules.
Displays the IP policies.
Deletes the specified IP policy.
Uses these commands to configure an IP
policy for an IPSec office tunnel rule.
Binds the IP policy to an IPSec rule.
<rule index>
Turns the IP policy on or off.
<Yes|No>
Sets the local starting IP address.
<IP>
Sets the IP policy's protocol.
<1:ICMP | 6:TCP
| 17:UDP>
Turns control ping on or off.
<Yes|No>
Sets the control ping IP address.
<IP>
Sets the local address type.
<0:single |
1:range |
2:subnet>
Sets the local ending IP address or
<IP>
subnet mask.
Sets the local starting port number.
<port>
Sets the local ending port number.
<port>
Sets the remote address type.
<0:single |
1:range |
2:subnet>
Sets the remote starting IP address.
<IP>
Sets the remote ending IP address or
<IP>
subnet mask.
Sets the remote starting port number.
<port>
Sets the remote ending port number.
<port>
Turns branch tunnel NAT address
<Yes | No>
mapping on or off.