Figure 39 Menu 11.1.2: Applying Nat To The Remote Node; Table 27 Applying Nat In Menus 4 & 11.1.2 - Nortel 222 User Manual

Figure 39 Menu 11.1.2: Applying NAT to the Remote Node

Menu 11.1.2 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 27 describes the fields in
Table 27 Applying NAT in Menus 4 & 11.1.2
Field
Network
Address
Translation
Chapter 9 Network Address Translation (NAT) 109
Figure
Description
When you select this option the SMT uses Address
Mapping Set 1 (menu 15.1 -
page 110 for further discussion). Choose Full Feature if
you have multiple public WAN IP addresses for your
Business Secure Router.
When you select Full Feature you must configure at least
one address mapping set!
NAT is disabled when you select this option.
When you select this option the SMT uses Address
Mapping Set 255 (menu 15.1 -
page 110). Choose SUA Only if you have just one public
WAN IP address for your Business Secure Router.
Nortel Business Secure Router 222 Configuration — Advanced
39.
"Address Mapping Sets" on
"Address Mapping Sets" on
Options
Full Feature
None
SUA Only