Ftp Session Example Of Firmware File Upload; Tftp File Upload; Figure 104 Ftp Session Example Of Firmware File Upload - Nortel 222 User Manual

192 Chapter 15 Firmware and configuration file maintenance
7

FTP Session Example of Firmware File Upload

Figure 104 FTP Session Example of Firmware File Upload

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
More commands (found in GUI-based FTP clients) are listed earlier in this
chapter.
Refer to the
configurations that disallow TFTP and FTP over WAN.

TFTP file upload

The Business Secure Router also supports the uploading of firmware files using
TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP also works over
WAN, Nortel does not recommend doing this.
1
NN47922-501
(config.rom) to the Business Secure Router and renames it rom-0. Likewise
get rom-0 config.rom transfers the configuration file on the Business Secure
Router to your computer and renames it "config.rom." See
conventions" on page 179
Enter "quit" to exit the ftp prompt.
Note: The Business Secure Router automatically restarts after a
successful file upload.
"Remote Management" on page 209
To use TFTP, your computer must have both Telnet and TFTP clients. To
transfer the firmware and the configuration file, follow the procedure shown
next.
for more information about filename conventions.
section to read about
"Filename