Chapter 6 Remote Node Setup; Introduction To Remote Node Setup; Remote Node Setup - Nortel 222 User Manual

Chapter 6

Remote Node setup

This chapter shows you how to configure a remote node.

Introduction to Remote Node setup

A remote node is required for placing calls to a remote gateway. A remote node
represents both the remote gateway and the network behind it across a WAN
connection. Note that when you use menu 4 to set up Internet access, you are
actually configuring a remote node. The following describes how to configure
Menu 11.1 Remote Node Profile, Menu 11.1.2 - Remote Node Network Layer
Options and Menu 11.1.4 - Remote Node Filter.
Remote Node setup
From the main menu, select menu option 11 to open Menu 11 Remote Node
Setup
Enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for
your regular ISP. Enter 2 to open Menu 11.1 Remote Node Profile (Backup
ISP) and configure the setup for your Dial Backup port connection.
(Figure 25).
Nortel Business Secure Router 222 Configuration — Advanced
85