Restore Using Ftp; Figure 97 Telnet Into Menu 24.6 - Nortel 222 User Manual

Restore Using FTP

For details about back up using FTP and TFTP, refer to
on page 180.

Figure 97 Telnet into Menu 24.6

To transfer the firmware and configuration file to your workstation,
follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Business Secure Router. Then type
"nnadmin" and SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the Business Secure Router. This restores the
configuration to your Business Secure Router.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Business Secure Router
manual.
1
Launch the FTP client on your computer.
2
Enter open, followed by a space and the IP address of your Business Secure
Router.
3 Press [ENTER] when prompted for a username.
4
Enter your password as requested (the default is "PlsChgMe!").
5
Enter bin to set transfer mode to binary.
6
Find the rom file (on your computer) that you want to restore to your Business
Secure Router.
7
Use put to transfer files from the Business Secure Router to the computer, for
example, "put config.rom rom-0" transfers the configuration file config.rom
on your computer to the Business Secure Router. See
on page 179
Chapter 15 Firmware and configuration file maintenance 187
Menu 24.6 -- System Maintenance - Restore Configuration
Press ENTER to Exit:
for more information about filename conventions.
Nortel Business Secure Router 222 Configuration — Advanced
"Backup configuration"
"Filename conventions"