Restoring The Factory Default Configuration Settings; Procedure To Use The Reset Button; Uploading A Configuration File Via Console Port - Nortel BSR222 Configuration

46 Chapter 2 Introducing the WebGUI
The MAIN MENU screen appears.

Restoring the factory default configuration settings

If you just want to restart the Business Secure Router, press the rear panel RESET
button for one to three seconds.
If you forget your password or cannot access the SMT menu, you must reload the
factory default configuration file or use the RESET button the back of the
Business Secure Router to restore the factory default configuration. Uploading
this configuration file replaces the current configuration file with the factory
default configuration file. All previous configurations are lost, and the speed of
the console port is reset to the default of 9 600 bp/s with 8 data bit, no parity, one
stop bit and flow control set to none. The password is also reset to PlsChgMe!.

Procedure to use the reset button

Press the rear panel RESET button for longer than three seconds to return the
Business Secure Router to the factory defaults.

Uploading a configuration file via console port

1
Download the default configuration file from the Nortel FTP site, unzip it and
save it in a folder.
2
Turn off the Business Secure Router, begin a terminal emulation software
session and turn on the Business Secure Router again. When you see the
message Press Any key to enter Debug Mode within 3 seconds, press any key
to enter debug mode.
3 Enter y at the prompt to go into debug mode.
4 Enter atlc after the Enter Debug Mode message displays.
NN47922-500
Note: The management session automatically times out when the time
period set in the Administrator Inactivity Timer field expires (default
five minutes). Simply log back on to the Business Secure Router if this
happens to you.