Nortel Meridian M1250 User Manual page 35

Introduction
A short horizontal line, called the cursor, shows where your dial-pad entries will appear on the screen.
First you enter hours (00-24) using the dial pad. The cursor automatically moves to the next spot. Here
you enter minutes (00-59). When the cursor jumps to the last spot you enter seconds (00-59).
Pressing the key moves the cursor to the start of the next input field. Pressing this key while in
the "Secs" field causes the cursor to jump back to the start.
After seconds, the cursor jumps back to hours, so that you can correct any mistakes. To correct a
mistake, enter the change right over the old entry. You can jump over an entry that is already correct
without changing it, to get to a mistake, by pressing
* to save the change.
Press # to return to the Options menu.
Setting the Date
If you press 5 on the first screen of the Options menu, you see this screen:
SET DATE
Day:___ Month:
* <change>
This screen works like the time screen. First you enter the day (01-31), then the month (01-12), and then
the year (00-99). Again, the cursor jumps back to the beginning so that you can correct any mistakes.
When you have set the date properly, press * to save the change.
Press # to return to the Options menu.
Setting the time and date format
If you press 6 on the first screen of the Options menu, you see this screen:
DISPLAY OPTIONS
1. TIME
. When you have set the time properly, press
Year:
# <exit>
2. DATE
# <exit>
• • • • 29 • • • •