Controlling Did Routes - Nortel Meridian M1250 User Manual

Convenience features

Controlling DID routes

Direct inward dialing permits incoming calls from outside lines that would normally be directed to the
console to be routed to a preselected destination. Incoming DID digit conversion translates the digits that
are actually dialed into digits that correspond to internal extensions. You can direct calls coming in on
DID trunks either to a set of extensions that are programmed as night destinations, or you can direct them
to normal extensions.
• • • • 106 • • • •
1
Press an idle lpk key.
2
Press drc.
3
Press # to see the status
of all DID routes.
Dial the route access
code to see the status of
a specific DID route.
The lpk indicator goes on.
The drc indicator goes on.
The drc. indicator goes on
steadily to show that all
routes are in day mode.
The drc. indicator flashes
to show that some or all
routes are in night mode.
The drc. indicator goes on
steadily to show that the
route is in day mode. The
drc. indicator flashes to
show that the route is in
night mode.