AC–24
Ohmmeter
–
ELECTRICAL TYPE POWER HEATER
AIR CONDITIONING
INSPECTION
1.
DRAIN ENGINE COOLANT
2.
REMOVE AIR CLEANER ASSEMBLY
3.
REMOVE GLOW PLUGS
(a)
Remove the glow plug cap.
(b)
Remove the 3 bolts.
(c)
Remove the glow plug plate.
(d)
Remove the glow plug stay.
(e)
Remove the 3 glow plugs.
I12479
4.
INSPECT GLOW PLUGS
Using an ohmmeter, check that there is continuity between the
glow plug terminal and ground.
Standard resistance at 20°C (68°F):
Approx. 0.22 Ω
If there is continuity, replace the glow plug.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
5.
REINSTALL GLOW PLUGS
(a)
Install the 3 glow plugs.
I12489
(b)
Install the glow plug stay.
(c)
Install the glow plug plate.
(d)
Install the 3 bolts.
(e)
Install the glow plug cap.
6.
REINSTALL AIR CLEANER ASSEMBLY
7.
FILL ENGINE COOLANT
AC29U–01