Toyota AVENSIS 1999 Supplement Manual page 143

MX–16
MANUAL TRANSAXLE (E251)
26.
27.
Pull up the No.3 shift fork shaft, remove the No.1 shift fork shaft.
HINT:
At the time of reassembly, please refer to the following item.
When it is difficult to push the fork shaft through the reverse shift
fork, pull up the No.3 shift fork shaft.
Q08124
28.
Using a magnetic finger, remove the interlock roller from the re-
verse shift fork.
Q08125
29.
(a)
(b)
Q08126
30.
(a)
(b)
31.
(a)
(b)
Z00182
32.
(a)
(b)
33.
(a)
(b)
34.
35.
– MANUAL TRANSAXLE ASSEMBLY
REMOVE NO.1, NO.2 SHIFT FORKS AND SHIFT HEAD
SET BOLT
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
REMOVE NO.1 SHIFT FORK SHAFT
REMOVE INTERLOCK ROLLER
REMOVE NO.2 SHIFT FORK SHAFT, SHIFT HEAD
AND NO.1 SHIFT FORK
Pull out the No.2 shift fork shaft.
Remove the shift head and No.1 shift fork.
REMOVE NO.3 SHIFT FORK SHAFT WITH REVERSE
SHIFT FORK AND NO.2 SHIFT FORK
Pull out the No.3 shift fork shaft with the reverse shift fork.
Remove the No.2 shift fork.
REMOVE SNAP RING
Using 2 screwdrivers and a hammer, remove the snap
ring and reverse shift fork from the No.3 shift fork shaft.
Using 2 screwdrivers and a hammer, remove the 3 snap
rings from the No.1, No.2 and No.3 shift fork shafts.
REMOVE INPUT AND OUTPUT SHAFTS ASSEMBLY
Leaning the output shaft to the differential side, remove
the input shaft assembly.
Lift up the differential case assembly, remove the output
shaft assembly.
REMOVE DIFFERENTIAL CASE ASSEMBLY
Remove the oil pump drive gear.
Remove the differential case assembly.
REMOVE MAGNET FROM TRANSAXLE CASE
REMOVE TRANSMISSION OIL PUMP ASSEMBLY
AND OIL PIPE