Toyota AVENSIS 1999 Supplement Manual page 15

IN–10
Match marks
– FOR ALL OF VEHICLES
INTRODUCTION
(3) Even in cases of a minor collision where the SRS
does not deploy, the steering wheel pad (See Pub.
No. RM599E, page RS–15), front passenger airbag
assembly (See Pub. No. RM599E, page RS–28),
side airbag assemblies (See page RS–11), curtain
shield airbag assemblies (See page RS–25) and
seat belt pretensioners (See Pub. No. RM599E,
page BO–152) should be inspected.
(4) Never use SRS parts from another vehicle. When
replacing parts, replace them with new parts.
(5) Before repairs, remove the airbag sensor if shocks
are likely to be applied to the sensor during repairs.
(6) Never disassemble and repair the airbag sensor as-
sembly, side airbag sensor assembly, steering
wheel pad, front passenger airbag, side airbag or
seat belt pretensioner in order to reuse them.
(7) If the airbag sensor assembly, side airbag sensor
assembly, steering wheel pad, front passenger air-
bag, side airbag or seat belt pretensioner have
been dropped, or if there are cracks, dents or other
defects in the case, bracket or connector, replace
them with new ones.
(8) Do not directly expose the airbag sensor assembly,
side airbag sensor assembly, steering wheel pad,
front passenger airbag, side airbag or seat belt pre-
tensioner to hot air or flames.
(9) Use a volt/ohmmeter with high impedance (10 kΩ/V
minimum) for troubleshooting of the electrical cir-
cuit.
(10) Information labels are attached to the periphery of
the SRS components. Follow the instructions on the
notices.
(11) After work on the supplemental restraint system is
completed, check the SRS warning light (See Pub.
No. RM599E, page DI–152).
(c) SPIRAL CABLE (in Combination Switch)
The steering wheel must be fitted correctly to the steering
column with the spiral cable at the neutral position, other-
wise cable disconnection and other troubles may result.
Refer to Pub. No. RM599E, page SR–18 of this manual
concerning correct steering wheel installation.
R11910