Toyota AVENSIS 1999 Supplement Manual page 216

SR–16
–
STEERING
INSTALLATION
1. INSTALL PULLEY COVER
Install the pulley cover to the PS vane pump with the bolt.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
2. INSTALL PS VANE PUMP ASSEMBLY
Install the PS vane pump to the pulley bracket and engine with
the 3 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
3. CONNECT PRESSURE FEED TUBE
Place a new gasket to the pressure feed tube and connect them
with the union bolt.
Torque: 52 N·m (525 kgf·cm, 38 ft·lbf)
4. CONNECT RETURN HOSE
Connect the return hose with the clip.
5. INSTALL VANE PUMP PULLEY
(a) Install the woodruff key to the vane pump shaft.
(b) Install the vane pump pulley.
(c) Using SST to stop the pulley rotating, torque the nut.
SST
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
6. INSTALL DRIVE BELT
SST
(a) Install the drive belt to the pulley.
F04155
(b) Adjust drive belt tension with the belt tension adjusting
bolt (See page SR–1).
(c) Torque the idler pulley set nut.
Torque: 38 N·m (390 kgf·cm, 28 ft·lbf)
7. BLEED POWER STEERING SYSTEM
(See Pub. No. RM599E on page SR–5)
F08958
POWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)
09960–10010 (09962–01000, 09963–01000)
SR0WG–01