Toyota AVENSIS 1999 Supplement Manual page 243

SUPPLEMENTAL RESTRAINT SYSTEM
H11616
H11617
– CURTAIN SHIELD AIRBAG ASSEMBLY
INSPECTION
1. VEHICLES NOT INVOLVED IN COLLISION
(a) Do a diagnostic system check. (See Pub. No.RM599E on
page DI–152)
(b) Do a visual check which includes the following items with
the curtain shield airbag assembly installed in the vehicle.
Check cuts, minute cracks or marked discoloration on the
front pillar garnishes.
2. VEHICLE INVOLVED IN COLLISION AND AIRBAG IS
NOT DEPLOYED
(a) Do a diagnostic system check. (See Pub. No. RM599E on
page DI–152)
(b) Do a visual check which includes the following items with
the curtain shield airbag assembly removed from the ve-
hicle.
Check cuts and cracks, or marked discoloration of
S
the curtain shield airbag assembly.
Check cuts and cracks in wire harnesses, and chip-
S
ping in connectors.
CAUTION:
For removal and installation of the curtain shield airbag as-
sembly, see page RS–23 and RS–32. Be sure to follow the
correct procedure.
3. VEHICLE INVOLVED IN COLLISION AND AIRBAG IS
DEPLOYED
(a) Do a diagnostic system check. (See Pub. No. RM599E on
page DI–152)
(b) Do a visual check which includes the following items with
the curtain shield airbag assembly removed from the ve-
hicle.
Check the curtain shield airbag installation part of
S
the instrument panel reinforcement.
Check the damage to the connector and wire har-
S
ness.
HINT:
If the front pillar garnish or instrument panel reinforcement are
deformed, never repair it. Always replace it with a new one.
RS–25
RS0IT–01