Toyota AVENSIS 1999 Supplement Manual page 280

Adhesive
Pillar Garnish
Cover
BODY
(c) Use a scraper to remove any excessive or protruding
adhesive.
(d) Hold the windshield glass in place securely with protec-
tive tape or equivalent until the adhesive hardenes.
NOTICE:
Take care not to drive the vehicle during the time described
in the table below.
BO3986
11. INSPECT FOR LEAKAGE AND REPAIR
(a) Do a leak test after the hardening time has elapsed.
(b) Seal any leakage with sealant.
Part No. 08833–00030 or equivalent
12. APPLY ADHESIVE AT MOULDING INSTALLATION
AREA
Coat the glass with adhesive at the moulding installation area.
Part No. 08833–00030 or equivalent
Adhesive
BO3671
13. INSTALL WINDSHIELD MOULDING
Place the moulding onto the body and tap it by hand.
14. INSTALL THESE PARTS:
(a) Install the front part of roof headlining.
(b) Install the inner rear view mirror
H03503
(c) w/ Curtain Shield Air Bag:
(1)
(2)
Torque: 5 N·m (51 kgf·cm, 44 in.·lbf)
(3)
(4)
NOTICE:
2 Clips
Be sure to tighten the bolt.
(5)
H11626
(d) Install the front pillar garnishes.
– WINDSHIELD
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
Remove the protection cover.
Install the 2 bolts.
Install the front pillar garnish.
Install the pillar garnish cover and bolt.
Fell the pillar garnish cover.
Minimum time prior to driving the vehicle
1.5 hours
5 hours
24 hours
BO–9