Toyota AVENSIS 1999 Supplement Manual page 106

DI–14
4 Check curtain shield airbag squib (RH).
Curtain
Shield
Airbag
→ ←
Squib (RH)
ACC ON
or
Check Connector
E1 Tc
H01018
AB0118 AB0119
H11643
R13006
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
Airbag
Sensor
Assembly
DTC 82
H11661
– SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn ignition switch to LOCK.
(b) Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the curtain shield airbag assembly (RH) connec-
tor.
(d) Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
(a) Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
(b) Clear DTC stored in memory.
(See step 5 on page DI–153 of Pub. No. RM599E)
(c) Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
(d) Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
(e) Check DTC.
(See page DI–152 of Pub. No. RM599E)
OK:
DTC 82 is not output.
HINT:
Codes other than code 82 may be output at this time, but they
are not relevant to this check.
NG Replace curtain shield airbag assembly (RH).