SA–8
SUSPENSION AND AXLE
(b)
89.3 – 90.3 mm
(3.52 – 3.56 in.)
F02277
3.
Vinyl Tape
HINT:
S
S
W01994
(a)
(b)
(c)
4.
(a)
(b)
(c)
NOTICE:
Do not tap the roller.
(d)
5.
Before assembling the boot, pack the outboard joint shaft and
boot with grease in the boot kit.
6.
(a)
(b)
(c)
(d)
–
FRONT DRIVE SHAFT
RH drive shaft:
Using a steel plate and press, install a new dust cover until
the distance from the tip of center drive shaft to the dust
cover reaches the specification, as shown in the illustra-
tion.
TEMPORARILY INSTALL NEW OUTBOARD AND IN-
BOARD JOINT BOOTS WITH NEW BOOT CLAMPS
Before installing the boots (and dynamic damper), wrap
the spline of the outboard joint shaft with vinyl tape to pre-
vent them from being damaged.
Before installing the boots (and dynamic damper), place
new clamps to each of them and then install boots to drive
shaft.
Temporarily install a new outboard joint boot with 2
clamps to the drive shaft.
Temporarily install the dynamic damper with clamp to the
drive shaft.
Temporarily install a new inboard joint boot with 2 clamps
to the drive shaft.
INSTALL TRIPOD
Place the beveled side of the tripod axial spline toward the
outboard joint.
Align the matchmarks placed before removal.
Using a brass bar and hammer, tap in the tripod to the
drive shaft.
Using a snap ring expander, install a new snap ring.
INSTALL BOOT TO OUTBOARD JOINT
Grease capacity: (Color = Black)
85 – 105 g (3.00 – 3.70 oz.)
INSTALL INBOARD JOINT SHAFT TO OUTBOARD
JOINT SHAFT
Pack the inboard joint shaft and boot with grease in the
boot kit.
Grease capacity: (Color = Yellow)
120 – 130 g (4.23 – 4.59 oz.)
Align the matchmarks placed before removal.
Install the inboard joint shaft to the outboard joint shaft.
Temporarily install the boot to the inboard joint shaft.