Toyota AVENSIS 1999 Supplement Manual page 182

Matchmarks
Matchmarks
–
SUSPENSION AND AXLE
DISASSEMBLY
1. CHECK DRIVE SHAFT
(a) Check to see that there is no obvious play in the outboard
joint.
(b) Check to see that the inboard joint slides smoothly in the
thrust direction.
(c) Check to see that there is no obvious play in the radial
direction of the inboard joint.
(d) Check the boots for damage.
N00191
2. REMOVE INBOARD AND OUTBOARD JOINT BOOT
CLAMPS
Using a side cutter, cut the 4 boots clamps and remove them.
3. REMOVE INBOARD JOINT SHAFT
(a) Place matchmarks on the tripod, inboard and outboard
joint shafts.
NOTICE:
Do not punch the marks.
(b) Remove the inboard joint shaft from the outboard joint
shaft.
4. REMOVE TRIPOD
(a) Using a snap ring expander, remove the snap ring.
FA1615
(b) Place matchmarks on the outboard joint shaft and tripod.
NOTICE:
Do not punch the marks.
(c) Using a brass bar and hammer, remove the tripod from
the drive shaft.
NOTICE:
Do not tap the roller.
5. REMOVE INBOARD JOINT BOOT
6. RH drive shaft:
SA1443
REMOVE DYNAMIC DAMPER
(a) Using a side cutter, cut the dynamic damper clamp and re-
move it.
(b) Remove the dynamic damper.
7. REMOVE OUTBOARD JOINT BOOT
NOTICE:
Do not disassemble the outboard joint.
FRONT DRIVE SHAFT
SA–5
SA10B–02