Throttle Body Installation - Suzuki AN650 2002 Service Manual

7-22 FUEL SYSTEM AND THROTTLE BODY
• Install the IAC hose connector.
Replace the O-ring with a new one.
• Apply thin coat of the engine oil to the new O-ring.
• Install the synchronizing screw to the original setting by turn-
ing the screw in until it lightly seats, and then backing it out
the same number of turns counted during disassembly.
Replace the O-ring with a new one.
• Apply thin coat of the engine oil to the new O-ring.

THROTTLE BODY INSTALLATION

Installation is in the reverse order of removal. Pay attention to
the following points:
• Connect the throttle pulling cable and throttle returning cable
to the throttle cable drum.
• Adjust the throttle cable play with the cable adjusters.
Refer to page 2-19 for details.
THROTTLE BODY CLAMP POSITION
VIEW OF TOP
#1
10˚
LH
IAC hose
#1
Air cleaner side
#2
Top mark
#2
Intake pipe side
Forward
RH
Backward