Suzuki AN650 2002 Service Manual page 161

• Install the pulley position sensor 1 with the sensor pushed
toward the primary pulley shaft side.
CVT BELT BRAKE-IN PROCEDURES
• It is necessary to allow the CVT belt to "BRAKE-IN" before
subjecting the CVT to maximum stresses.
Brake -in engine speed
Initial 800 km (500 miles): Below 4 000 rpm.
NOTE:
When the CVT belt is new, the engine rpm may jump briefly
under hard acceleration due to the smoothness of the belt.
CLAMP LOCATION
30˚ 30˚ 30˚ 30˚
30˚ 30˚ 30˚ 30˚
35˚ 35˚
CVT 5-27