• Place a piece of clean rag on the CVT casing mating face to
prevent the CVT belt from scratches.
• Install the CVT belt so that the direction mark on the CVT belt
points in the normal turning direction.
Never touch the side walls of the CVT belt.
• Place a piece of clean rag on the primary pulley faces to pre-
vent them from scratches.
SECONDARY PULLEY ASSEMBLY
• Install the secondary pulley assembly.
• Remove the rags.
* Degrease the secondary pulley faces completely.
* Use caution not to cause scratches on the pulley
surfaces due to their contact.
• Check that the secondary pulley is located inwardly relative to
the primary pulley.
CVT
5-21